Great for the CCNA Lab at low cost!
Console boot up screen shots are shown with this advertisement
Note that console access is via RJ45 to your serial port, standard 9600 comms
Fixed-configuration, managed 10/100 Mbps switches providing basic workgroup connectivity for small to midsize networks.
These wire-speed desktop switches come with Standard Image software features and offer Cisco IOS® Software functions for basic data, voice, and video services at the edge of the network.
CISCO 24 Port + 2x 100Base FX uplink ports
Serial FCZ1044X0GA
10/100Mbps managed switch
No rack ears
COSMETIC NOTE: The front panel normally unclips from the front, this one still does but the ONE issue these older routers have is that after being in a rack for a long time, the plastic used on the front panel becomes brittle - i.e the locking pins break off.
So this front panel is firmly held in place BUT a strip of tape has been run along the top of the panel to keep it tightly in place.
The only control is the MODE button anyway and that is working fine.
Tested, both bootup and console throughput are fine but the FX ports not tested - see the screen shot re console access.
No passwords on the console
GENERAL INFO:
I went into various menu's (break the startup sequence with the Mode button) and made sure the CLI was working correctly on all switches - information on how to do this is available online.
All photographs of the equipment are of the actual equipment, don't be fooled by some photos I see online, they are offering say a C2950T and yet the photo is of a stock standard C2950
To get the most out of these switches, the user should know some basic networking knowledge and use of the CLI to setup the switch properly although help is available for all commands when talking with the switch via the console.
This switch is not your domestic "plug it in and away you go" you need to set them up properly via the console port.
