Rohde & Schwarz Test Equipment
Set of two enclosure sprung side carry handles (recessed)
Removed from the case of a UPSF2 but quite likely to be found in other high quality German designed/built test equipment
These handles are U shaped with a special hinge that provides for spring back locking into the recesses of the equipment case.
Complete with all required hardware, even the small impact pads which protect against case damage when the handle is placed back into the side recesses.
If these were being considered for use with other equipment cases, the description is:
Aluminium construction, anodised (dull grey) surface
Each handle is substantial at 300g weight (originally supporting equipment weighing approximately 20Kg)
Dimensions: 140mm wide x 70mm deep with the handle cross-section being 15mm wide x 13mm high
The spring mechanism is easily inserted/removed on each side of the handle and locked into place with hex grub screws
COSMETIC CONDITION:
Clean with only slight scratches (no surface damage at all on one handle)
No structural damage to either handle
Stored and supplied in sealed plastic to maintain the condition
