UNKNOWN MANUFACTURER - IEC Socket (With M205 Fuse Holder)
Ex UK broadcast industry modules, I believe these IEC sockets were UK manufactured
Safety standards stamped into the body
Dual language fuse holder front panel
But with all that, NO NAME of the manufacturer
Rated to 10A 250V AC
Standard M205 fuse holder, non-switching, which holds the active fuse and a slot for a spare fuse
Fuse already installed/supplied (I cannot read the fuse manufacturer's name as it is way too small but the rating is 500mA Slo Blow)
NO EMI Filter built in
NO boot to the rear
DIMENSIONS:
19.5mm deep x 44.75mm wide x 34.25mm high
Mounting nuts (for the screws) are permanently attached to the body
Mounting holes are spaced 35.25mm apart
Bolts to suit are supplied (2)
Solder terminals to the rear
COSMETIC CONDITION:
USED
CLEAN
De-soldered the previous hard wiring, all three pins are straight and true ***
*** This is important - do NOT use excessive heat when reusing these sockets as I noticed the plastic used "softens" fairly easily which can result in misaligned pins - this happened to me a couple of times, the longer EARTH pin seemed to be the most susceptible. I am not talking about "normal" soldering but at times I need to apply heat for a long period when removing the old wires and that is when I had the soft plastic problem.
Stored and supplied in individual sealed plastic packets
