USED Equipment "pull"
Ex ROHDE & SCHWARZ RF Test Equipment
Low loss RF lead/adaptor which is most often used for equipment internal PCB connection to the external world.
BNC female (bulkhead mounting) with a short 400mm lead terminated with a right-angle Mil Spec SMB Plug for the internal PCB.
USED but fully functioning!
This RF interconnect lead is suitable for use up to around 4Ghz in amateur and commercial environments across many types of equipment e.g test cables, communications equipment and radio frequency test equipment and of course, custom projects!
UNIDENTIFIED MANUFACTURER - RF Interconnect Adaptor Lead
I strongly suspect this is Huber + Suhner product
BNC-Female to R/A (right angle) SMB Female
MIL spec
All Gold plated metal
Panel mounting BNC (female) bulkhead connector is ISOLATED from the metal front panel, it uses an indented nylon ring at the rear along with an insulating fiber washer, normal screw on mounting (nut supplied)
Coax type is unknown, definitely 50 Ohm and probably RG316 or similar
Short lead at only 400mm length
No identification stamps or printing is visible on either the connectors or the coax except the W numbering on the heatshrink at each end of the lead. Those numbers are equipment manufacturer number codes, important as there are a LOT of these interconnect cables inside the equipment!
COSMETIC CONDITION:
USED
Clean/shiny connectors - no damage at all
Coax is completely undamaged - no kinks, cuts or other damage.
