Akai AP-002 turntable spare part
Plinth isolating feet
Black rubber
Special fitting method but useable on other turntables
Clean
These feet are designed to fit into holes at the base of the turntable, not held by screws/bolts
3 of the feet are the same shaft length however one is has a shorter shaft due to the shaft "tearing" while being removed however this shorter foot is still perfectly useable.
Dimensions per foot:
40mm diameter base
12mm base height
18mm from base to the bottom of the "locking groove" so this is the effective height that the turntable is lifted off the mounting surface
The "locking groove" is 3mm wide so the base this foot will fit into must NOT be thicker than 3mm
3 of the feet have a shaft length of 25mm
1 of the feet has a shaft length of 15mm
Mounting hole for this foot MUST be around 5mm, any larger and it will be a "sloppy" fit and if smaller it will not be possible to push the foot into the hole.
To use these, carefully insert into the hole at the base of the turntable plinth until the "locking groove" locks the foot in place
This must be done carefully and with some delicacy as I discovered while removing these - thus the one foot that has a shorter shaft!
