These might seem such an ordinary item but when if these switches fail then your turntable is often "dead in the water" or it the platter will not rotate when the arm is moved from rest position.
This microswitch came from a "parted out" C.D.C ST 510 but it is very likely that it will suit use with other turntables
C.D.C (Chup Denki Corporation) in Saitama, Japan
Basic Entry level turntable
Plastic plinth
Pressed metal base
Aluminium diecast platter
Semi-Automatic
C.D.C ST 510 Turntable Microswitch (ONLY)
Omron Tateisi Electronics (Japan)
Part #: 2375RA
Rated at 0.3A 250V AC
SPDT
Push On Release Off
Very nice actuator "feel" which quickly springs back to rest when released
Dimensions: 42mm x 18mm (to the tip of the actuator)
Solder tags
Two mounting holes, offset from each other, spaced 25mm apart
Supplied with the original mounting screws
CONDITION:
Excellent, no damage
TESTING:
Prior to dismantling the ST 510 I tested this switch operation, absolutely no problems at all
Stored in a sealed plastic bag
