null Skip to main content

C.D.C ST 510 Turntable Spare Part - Straight Tonearm With Counter Weight

CDC

$15.00
Condition:
Used
Minimum Purchase:
1 unit
Maximum Purchase:
1 unit
Shipping:
Calculated at Checkout

Oh Dear! This item has been sold but take a look around for other similar items

Good for a replacement tonearm or perhaps for that "project" turntable

 

C.D.C (Chup Denki Corporation) in Saitama, Japan

Basic Entry level turntable

Plastic plinth

Pressed metal base

Aluminium diecast platter

Semi-Automatic

 

C.D.C ST 510 Straight Tonearm with counter balance

Standard 9" format arm

Simple plastic/metal pivot

Headshell connector could be changed, attached to the tonearm shaft with two small Phillips screws

Tonearm shaft is aluminium

Actual measurement from pivot to headshell connector 184mm

Tonearm diameter is 7mm

Tonearm mass is estimated to be low (under 10g) although I cannot measure this, I have no scales that will measure weights this low.

Counter balance is solid metal, threaded

Brass tonearm support is 65mm length, with a slot ring at 41mm for the original locking circlip (NOT SUPPLIED)

 

Photograph shows the pivot system disassembled, it is very easy to reassemble.

Another photograph shows the connector close up, note the flat spot on the top and a very slight raised area at the bottom.

 

Tonearm is stored disassembled and it will be provided to the buyer this way - if being shipped it is the safest way of packing it.

 

Testing performed as outlined in the description. Used item, non returnable