null Skip to main content

C.D.C ST 510 Turntable Spare Part - Base Feet Suspension System (4)

CDC

$10.00
Condition:
Used
Minimum Purchase:
1 unit
Maximum Purchase:
1 unit
Shipping:
Calculated at Checkout

Oh Dear! This item has been sold but take a look around for other similar items

For a basic entry level turntable, CDC went to some trouble designing the turntable suspension system.

This set of 4 base feet/springs were removed from a CDC ST 510 which has been "parted out" but it is likely that these feet can be fitted to other turntable base units.

 

C.D.C (Chup Denki Corporation) in Saitama, Japan

Basic Entry level turntable

Plastic plinth

Pressed metal base

Aluminium diecast platter

Semi-Automatic

 

C.D.C ST 510 Turntable Base feet/suspension system

Made in Japan

Parts supplied:

4x rubber suspension units with internal spring

4x mounting screws

4x bottom section plastic feet with end padding

 

See the photographs to get an idea of how these go together but in brief, the base foot sits inside the rubber boot. This boot has a strong spring inside. Each base foot is "two part" - the boot and the foot, this gives considerable mechanical isolation between the surface the turntable is placed upon and the turntable itself.

The last photograph shows some guideline dimensions. The securing screw goes in from the bottom of the foot. The boot, where it fits into the base of the turntable has a 11mm OD "lip" - this is where the boot meets the turntable base and the screw comes up the centre of the boot and then into the metal base.

 

CONDITION:

No damage to any of the components

No degradation of the rubber

All parts are clean

 

Stored and supplied in a sealed plastic bag

Testing performed as outlined in the description. Used item, non returnable