Rohde & Schwarz Video Noise Meter Model UPSF2
Specifically designed for the measurement of spurious modulation from the television transmitter (see the block diagram providing a typical setup)
**FEET ONLY**
Old technology although still in use until 2002 at an Australian National Broadcast facility, but these feet could be useful for a UPSF2 restoration project or other equipment.
Although these feet came from the UPSF2, I strongly suspect they are used on other R & S test equipment and also look very similar to HP/Agilent feet
Set of four feet comprising two front adjustable feet and two rear fixed position feet
COSMETIC CONDITION:
Clean with no damage at all - supplied with the bolts/nuts for fixing to the casing
DIMENSIONAL DETAILS:
35mm wide x 42mm front to rear "block" with a 58mm long "sprung" rear leg. This leg moves through 90 degrees to raise the front of the test equipment 58mm from the "normal"
The centrally mounted bolt/nut is located 18mm from the front
The rear feet are also 35mm wide but 31mm front to rear and have a small piece of material attached to reduce sliding of the equipment.
On these rear feet the centrally mounted bolt/nut is located 12mm from the front
Please look at the photograph if something is unclear
Stored/supplied in sealed plastic
